How Add Fourth Tube to Any Good Receiver
An article by J F J Maher describes a tuned radio frequency amplifier with regeneration to be connected ahead of a receiver. It details a three coil network, a tapped plate coil and a two control setup for wavelength and regeneration, plus wiring to choke interference.
Schematic for a high gain regenerative amplifier unit
A vintage schematic describes a regenerative amplifier with a wide 1k to 100k ohm variable input, using a fifteen plate coil, six inch tubes, and plate coil mounting. It details wiring of detector, grid, and output circuits, panel layout, and battery binding posts for A and B supplies.
Storage Cells Give Long Service in B Circuit
Wet or storage B batteries should be bought by milli ampere capacity not voltage. Ampere capacity determines life after full charge. a 22-volt battery should never be charged. Charging uses a series lamp, polarity must be correct, use a voltmeter to check voltage, and ensure proper electrolyte and oil film on top.
MENTIONED IN THIS ARTICLE
Bat Agag
A. C
D. C
Radio frequency congestion across wavelengths
A list shows the number of stations sharing each wavelength. Ten operate on 240 meters, thirteen on 261, sixteen on 268, nineteen on 280, fourteen on 256, forty-seven on 360, seventeen on 400, seven in Canada on 440 and seven more on 450 meters.
MENTIONED IN THIS ARTICLE
Canada
Antenna System Needs Periodic Inspection
The antenna system should be periodically inspected to ensure wires are taut and slack is removed. Guy wires must be adjusted for equal pull, the mast checked for perpendicularity, and any excessive lean corrected with additional guy wires.
Meter Tests Current in Radio Circuits
The ammeter and milliammeter measure current in radio circuits. The milliammeter gauges currents in plate and grid circuits in milliamperes, one thousandth of an ampere.
Esperanto Radio Paper Established in Locarno Switzerland
A new Esperanto radio paper named Radio has been founded in Locarno following Venice conference recommendations. The first monthly issue appeared in April and promotes Esperanto as the international radio language through propaganda for radio and the language.
MENTIONED IN THIS ARTICLE
Radio
Locarno
Switzerland
Venice
Five Year Guarantee Promised for Radio Headphones
The article notes radios and headsets now offer a five year guarantee with careful handling. It contrasts with older headphones lasting up to ten years with proper care while warning of cheap short lived models fading as magnetism weakens. It highlights dropforged steel magnets as superior for lasting magnetic strength.
Government Stations Adopt Tube With Horizontal Socket Contact
Government stations announce use of a new tube design where contact with the socket is achieved by horizontal pressure. Knifelike prongs extend from the tube centre and provide positive wiping contact for reliable operation.
Insulators and Their Uses in Electrical Systems
A description of electrical insulators and their role in preventing current flow between conductors and nearby objects. It covers materials like hard rubber glass and porcelain and explains insulators hold charged conductors in a fixed position to prevent leakage.
Shielding Reduces Noise in Telephone Wires
Flexible wires connect phones using tinsel cord insulated with silk or cotton to minimize rubbing noises. Braided metal around the insulation shields against induction effects.
Steady Current Essential for Set Operation
The article explains that steady current from fresh batteries is crucial for clean reception in radio sets. It describes three element tubes with filament plate and grid, how current variations affect plate current and sound quality, and why keeping batteries charged prevents distortion and volume loss.
Condenser Decreases Broad Tuning Interference
Interference from local stations can be reduced by shunting a fixed condenser across aerial and ground posts. A simple two sheets foil condenser three inches square separated by paper works. Install a permanent mica dielectric condenser of .000025 microfarads capacity.
Electron Emission and Plate Current in Vacuum Tubes
In a heated tungsten metal in a vacuum electrons are emitted from the surface with an initial velocity depending on temperature. The plate’s positive potential attracts electrons from the filament, guiding a stream across the gap to make the space conductive and allow plate current to flow.
Ships near port ordered to minimize power usage
Government orders ships near port to reduce transmission power when sending near port waters. New guidance stresses non interference with broadcasts and warns offenders. General directive aims to ensure messages remain clear while avoiding unnecessary disruption.
MENTIONED IN THIS ARTICLE
New York
Currents in Radio Circuits Measured by Meters
A technical note explains measuring radio circuit currents with an ammeter and a milliammeter. The ammeter tracks plate current while the milliammeter gauges grid current in milliamperes.
Also Mentioned on This Page
J. F. J. Maher
Qurne
Rheo
Regen Wn
Radio Robert