Detecting and Remedying Open Short and Leakage in Radio Circuits
A practical guide to diagnosing open circuits, short circuits, and leakage in radio receivers. It explains using a series lamp with a 110 volt circuit to test for continuity, and describes basic steps to identify faults in components like tuning coils and other contacts.
Testing the Tune Circuit Grounding and Insulation Checks
Instructions describe testing for open circuits and bad contacts in a tune circuit. Use a battery and buzzer in series with test clips to detect continuity. Avoid using house lighting for ground tests to prevent a short. Ensure antenna lead insulation and proper grounding to prevent leakage and arcs.
Testing Telephone Cords and Crystal Detectors
Instructions describe testing continuity of telephone receiver circuits using a short insulated wire and tongue contact, checking diaphragms, and isolating weak receivers. It covers shorting tips to test open circuits, safe handling of magnets, and cleaning or resurfacing crystal detectors with alcohol, brushes, or removing surface layers.
Amateurs urged to play fair by radio regulations
Radio Inspector L R Schmidt warns nine of ten fans are honest but one is a poor sport. Amateurs should learn radio laws, use minimal power, limit to 200 meters wavelength, and avoid excessive calling. A 15 cent copy of rules is available from the government printing office.
MENTIONED IN THIS ARTICLE
L. R. Schimidt
Superintendent of Documents
Government Printing Office
Washington, D. C
Texas
Tips to the Radioist Improve aerial height and spacing for stronger signals
The higher the aerial, the stronger the signals. Increase flat top aerial height by five to ten feet. Add a variable condenser to the secondary or primary of a loose coupler to tune out undesired signals. Solder a flexible wire to tuning coil sliders to avoid poor contact. Extend spreaders for multiwire aerials from six to ten feet with four to six feet between wires. Two wires or more should be spaced adequately. more wires aren’t better if spacing is poor.
Grounding Aerials Averting Lightning Hazards
Aerials should be grounded with a copper wire No 4 B S gauge or larger to act as a lightning rod and protect the property. Do not use water gas or steam pipes inside the building as grounds since they may fail if put into service.
The Home Radio How to Make and Use It
A. Hyatt Verrill explains wireless telephony contrasts with telegraphy. continuous waves enable clear voice transmission while interrupted waves chop speech. transmitters and receivers separate roles. receivers simpler, guiding focus to radio telephony fundamentals.
Understanding the Receiving Set in Wireless Telephony
The article explains the main receiving set components the aerial tuner detector and receiver. It details aerial design long wires and insulation effects vertical or horizontal placement and the advantage of long lead-ins for apartments or hotels. It also compares crystal detectors and vacuum tubes and notes tuning aligns with the wave signals for listening.
Antenna Man Advances Radio Reception in Evanston
An Evanston man James B. Miller demonstrates a body antenna by touching a radiophone with his finger to receive K Y W broadcasts with near aerial performance. A second person touching Miller boosts volume while he acts as the antenna, with no roof aerial connection. He claims the method reduces static and envisions lower antennae using magnetic field pathways.
MENTIONED IN THIS ARTICLE
James B. Miller
Evanston
Battery searchlight advances extend range to half a mile
The pocket flashlight powered by small dry cells has evolved into a high power battery searchlight. Earlier models reached 500 feet, now designs achieve about 2,000 feet up to half a mile with six volts. A 7.5 inch adjustable focus and six shell reflector test show around 453 candlepower using a nitro tungsten lamp and poised reflector.
MENTIONED IN THIS ARTICLE
New York Herald
Preparation Said to Protect Wool from Moths
A European discovery claims a powder gives wool immunity to moths. The powder is mixed in water with a small amount of sulfuric acid for all wool and with acid for half wool. The wool fabric itself is not required for the application.
MENTIONED IN THIS ARTICLE
Europe
Also Mentioned on This Page
INS
Radio
Schmidt
the Home Radio
A. Hyatt Verrill
Petector
Chayke
Sun-Maid Raisin Growers
Fresno
Calif